Start VC and perform a standard Auto-Scan:Īfter the Auto-Scan is finished, you will see outputs like this:Īddress 01: Engine Labels: 06A-906-033-BGU.LBL How do I find out if the control modules in my car are documented? Please note that do to the amount of requests coming in we cannot respond to all emails (and sent out confirmations or status updates) but your files will added to the queue and we'll try to get the relating label files done as soon as possible. Please send these to us via email and make sure to attach an Auto-Scan from the car(s) you obtained the maps from as well. VCDS will now create pre-label files from the module you chose, once it's finished you will find this "map" file (file type/ending PLB, PLA and CSV) in the /VCDS/Logs/ folder. Type #2: To create map files from individual control modules, please perform the following procedure:Īddress: XX (Enter the address of the control module in question, e.g. VCDS will now automatically create pre-label files from all undocumented control modules, once it's finished you will find these "map" files (file type/ending PLB, PLA and CSV) in the /VCDS/Logs/ folder. Type #1: To create a map from all undocumented control modules in the car, please perform the following procedure: There are two ways how you can create such maps, if you are unsure about this procedure we recommend the first variant. If you are sending files, please attach an Auto-Scan from the car(s) you obtained the maps from too. After creating the "map" files (file type/ending PLB, PLA and CSV), you can find them in the /VCDS/Logs/ folder - please send them to us via email. You can help us by providing such maps from your car(s). We are continuously working on improving this wiki and the VCDS label files, therefore it's very helpful to have maps from modules which are either new, undocumented or incomplete yet. Current interfaces are able to create channel maps of Adaptation and Advanced Measuring Values, again only if an appropriate ROD file is present. If you run a Debug Level: 2 as described below, any control modules using UDS will be skipped and PLA/PLB files will not be retrieved if no ROD file is present. In other words, the Controller Channels Map function does not work with control modules using the UDS/ODX protocol if no ROD file is present. ROD file, there is no way for VCDS to interrogate all possible Measuring Blocks or Adaptation Values if those aren't already documented. ROD file for VCDS to interpret data and they do not support traditional Measuring Blocks or Adaptation channel numbers. Control modules using the newest UDS/ODX protocol require a special.VCDS Manual: Control Module Maps Special Notes These "map" files are useful for creating new label files or taking a "snapshot" of all available data from an ECU. VCDS supports "Control Module Maps", this function rapidly scans through all possible measuring block groups and/or adaptation channels on any ECU and writes a "map" file. 3 How do I find out if the control modules in my car are documented?.
0 kommentar(er)
